Altera Stratix V Avalon-ST Manual do Utilizador Página 70
- Página / 158
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Test Signals
Table 4-18: Test Interface Signals
The test_in bus provides run-time control and monitoring of the internal state of the IP core.
Signal Direction Description
test_in[31:0]
Input The bits of the test_in bus have the following definitions:
• [0]: Simulation mode. This signal can be set to 1 to accelerate
initialization by reducing the value of many initialization
counters.
• [1]: Reserved. Must be set to 1’b0
• [2]: Descramble mode disable. This signal must be set to 1
during initialization in order to disable data scrambling. You
can use this bit in simulation for both Endpoints and Root
Ports to observe descrambled data on the link. Descrambled
data cannot be used in open systems because the link partner
typically scrambles the data.
• [4:3]: Reserved. Must be set to 4’b01.
• [5]: Compliance test mode. Disable/force compliance mode.
When set, prevents the LTSSM from entering compliance
mode. Toggling this bit controls the entry and exit from the
compliance state, enabling the transmission of Gen1, Gen2
and Gen3 compliance patterns.
• [6]: Forces entry to compliance mode when a timeout is
reached in the polling.active state and not all lanes have
detected their exit condition.
• [7]: Disable low power state negotiation. Altera recommends
setting thist bit.
• [31:8]: Reserved. Set to all 0s.
For more information about using the test_in to debug, refer to
the Knowledge Base Solution How can I observe the Hard IP for
PCI Express PIPE interface signals for Arria V GZ and Stratix V
devices? in the Related Links below.
currentspeed[1:0]
Output Indicates the current speed of the PCIe link. The following
encodings are defined:
• 2b’00: Undefined
• 2b’01: Gen1
• 2b’10: Gen2
• 2b’11: Gen3
UG-01097_sriov
2014.12.15
Test Signals
4-35
Interfaces and Signal Descriptions
Altera Corporation
Send Feedback
- User Guide 1
- Datasheet 2
- Features 3
- Interface 4
- Release Information 7
- Device Family Support 7
- Example Designs 8
- Debug Features 8
- IP Core Verification 9
- Recommended Speed Grades 10
- Related Information 11
- Subscribe 12
- Qsys Subsystem Description 13
- Parameter Value 15
- Directory Description 16
- Parameter Settings 21
- Parameter Value Description 22
- SR-IOV System Settings 24
- Interrupt Capabilities 27
- Device Capabilities 29
- Error Reporting 30
- Link Capabilities 31
- Slot Capabilities 32
- Power Management 33
- PHY Characteristics 34
- Simulation Options 35
- Avalon-ST TX Interface 37
- Signal Direction Description 38
- Avalon‑ST RX Interface 40
- BAR Hit Signals 43
- Completion Side Band Signals 45
- Signal Directi 46
- Description 46
- Clock Signals 48
- Interrupt Interface 49
- Implementing MSI-X Interrupts 55
- LMI Signals 57
- Serial Data Signals 65
- Test Signals 70
- PIPE Interface Signals 71
- Byte Address 77
- MSI Registers 80
- MSI-X Capability Structure 82
- VF Device ID Register 96
- Page Size Registers 96
- Lane Error Status Register 98
- Bits Register Description 99
- Default Value 99
- Altera Corporation 100
- Registers 100
- Send Feedback 100
- Virtual Function Registers 102
- Name Description 103
- Reset and Clocks 107
- Hard IP for PCI Express 108
- Example Design 108
- UG-01097_sriov 109
- 2014.12.15 109
- Function Level Reset (FLR) 111
- Clock Domains 111
- Clock Summary 114
- Interrupts 115
- Error Handling 118
- Physical Layer Errors 119
- Data Link Layer Errors 119
- Transaction Layer Errors 120
- Error Type Description 121
- Status Bit Conditions 123
- IP Core Architecture 125
- Top-Level Interfaces 126
- Clocks and Reset 126
- Transceiver Reconfiguration 126
- Data Link Layer 127
- Physical Layer 129
- TX Packets 130
- Design Implementation 136
- CONF_DONE 137
- Endpoint Reset 137
- Root Port Reset 137
- SDC Timing Constraints 138
- Debugging 143
- Setting Up Simulation 146
- Use Third-Party PCIe Analyzer 148
- BIOS Enumeration Issues 148
- Address[31:2] 149
- Figure A-6: I/O Read Request 151
- Additional Information 155
- Typographic Conventions 156
- Visual Cue Meaning 157
Manuais e produtos relacionados com Instrumentos de medida Altera Stratix V Avalon-ST
Instrumentos de medida Altera 100G Development Kit, Stratix IV GT Edition Manual do Utilizador
(80 páginas)
(80 páginas)
Instrumentos de medida Altera 100G Development Kit, Stratix V GX Edition Manual do Utilizador
(76 páginas)
(76 páginas)
Instrumentos de medida Altera Arria II GX FPGA Development Board, 6G Edition Manual do Utilizador
(62 páginas)
(62 páginas)
Instrumentos de medida Altera Cyclone IV GX Transceiver Starter Board Manual do Utilizador
(40 páginas)
(40 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.071 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais