Altera HyperTransport MegaCore Function Manual do Utilizador descarregar pdf (Página 15)

Chapter 2: Getting Started 2–7

MegaCore Function Walkthrough

5. Click Next. The Clocking Options tab displays, as shown in Figure 2–7.

6. You set the clocking options for your application on the Clocking Options tab. For

more information about the available options, refer to “Clocking Options” on

page 3–7 and Table A–3 on page A–3. For this walkthrough, use the default

settings, which are shown in Figure 2–7.

1 HyperTransport link clock frequencies of 500 MHz are only supported in

Stratix II and Stratix II GX devices.

Figure 2–6. Parameterize—Base Address Registers Tab

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 75 76

User Guide 1
UG-MCHYPRTRNS-1.12 2
Contents 3
Appendix C. Example Design 4
Additional Information 4
Release Information 5
Device Family Support 5
Introduction 6
Features 6
Performance 7
Notes to Table 1–4: 8
Notes to Table 1–5: 8
2. Getting Started 9
MegaCore Function Walkthrough 10
Step 1: Parameterize 13
Step 2: Set Up Simulation 17
Figure 2–9. Set Up Simulation 18
Step 3: Generate 19
Notes to Table 2–1: 20
Compile the Design 21
Simulate the Design 21
Program a Device 22
Set Up Licensing 23
Example Quartus II Project 24
■ input_ht_vector.dat 25
■ output_ht_vector.dat 25
■ input_ui_vector.dat 25
■ output_ui_vector.dat 25
About the Test Vectors 26
3. Specifications 27
HT Systems 28
HT Flow Control 29
Physical Interface 30
Protocol Interface 31
End-Chain Handler 32
Rx Claimed Buffers 32
Tx Buffers 32
Scheduler 32
Clocking Options 33
Shared Rx/Tx Clock 34
Shared Ref/Tx Clock 34
Chapter 3: Specifications 3–9 35
Preliminary 35
Shared Rx/Tx/Ref Clock 36
Note to Figure 3–8: 37
HT Link Rx Signals 42
HT Link System Signals 42
HT Link Tx Signals 42
Notes to Table 3–6: 45
Notes to Figure 3–10: 46
Notes to Figure 3–11: 46
Notes to Figure 3–12: 47
Notes to Figure 3–13: 47
Notes to Table 3–8: 51
Addr[39:8] 52
Notes to Figure 3–16: 53
Notes to Figure 3–17: 53
Notes to Figure 3–18: 54
User Interface System Signals 55
Using PLL Resets 55
CSR Interface Signals 56
CSR Module 57
Notes to Table 3–13: 58
Notes: to Table 3–16: 60
A. Parameters 67
Base Address Registers 68
Advanced Settings 69
A–4 Appendix A: Parameters 70
Parameter Lists 70
Guidelines 71
C. Example Design 73
General Description 74
Typographic Conventions 76

Comentários a estes Manuais

Sem comentários

Altera HyperTransport MegaCore Function Manual do Utilizador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Altera HyperTransport MegaCore Function