Altera Cyclone II DSP Development Board Manual do Utilizador descarregar pdf (Página 44)

2–36 Reference Manual Altera Corporation

Cyclone II DSP Development Board August 2006

Memory Components

DIMM_SYNC_CLK SMA Connector (J11)

A special feedback clock signal called DIMM_SYNC_CLK is included on

the board with an SMA(J11) at the end of the trace near its termination

point resistor. This signal has two purposes:

■ You can use this signal as a test point SMA for eye diagrams of DDR2

signals using AC-coupled SMA connections to an oscilloscope.

■ You can use this signal as a board-level round trip delay estimator as

an optimal method in resynchronizing DDR2 DIMM read captures

with the internal clock (output from the PLL in Figure 2–12). The

length of DIMM_SYNC _CLK is the same as the output clocks

(.e.g.DIMM_CK_PO) and the return clocks (e.g.DIMM_DQSO).

102

104

113

126

135

147

156

165

203

212

224

Notes to Ta b le 2 –2 1:

(1) Blank cells indicate no connection.

(2) In the Cyclone II Signal Name column, some of the names are different than the

DIMM (J8) Signal Name due to the use of series resistors.

Table 2–21. DDR2 SDRAM DIMM Pin-Outs (Part 8 of 8) Note (1)

Cyclone II (U12)

Signal Name (2)

DIMM (J8) Signal

Name (2)

DIMM (J8) Pin

Number

Cyclone II (U12)

Pin Number

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 111 112

Sem comentários

Altera Cyclone II DSP Development Board Manual do Utilizador Página 44