Altera Cyclone II DSP Development Board Manual do Utilizador Página 109
- Página / 112
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Altera Corporation Reference Manual D–1
August 2006 Preliminary
Appendix D. Restoring the
Factory Design
Introduction
This appendix provides the following information:
■ “Factory-Programmed Factory Design”
■ “User Designs”
■ “Reprogramming the Factory Design to the EPSC64 Device (U17)”
Factory-Programmed Factory Design
The Cyclone™ II DSP development board is factory programmed with a
factory design stored in flash memory, the EPCS64 (SAFE EPCS) serial
configuration device (U17). When power is applied to the board, the on-
board logic downloads the factory design to configure the EP2C70 FPGA.
User Designs
The EPCS64 serial configuration device (U36) is used to store a user
design. When power is applied to the board, the on-board logic
downloads the user design to configure the EP2C70 FPGA.
Reprogramming the Factory Design to the EPSC64 Device (U17)
During the development process, you may accidentally overwrite the
factory design in the EPCS64 (SAFE EPCS) flash memory serial
configuration device (U17). Altera includes the Programmer Object File
(.pof) factory design in the DSP Development Kit, Cyclone II Edition, so you
can reprogram the Cyclone II DSP development board to the original
factory configuration.
- Reference Manual 1
- MNL-CII012805-1.1 2
- Contents 3
- About This Manual 5
- Typographic 6
- Conventions 6
- Chapter 1. Introduction 7
- Features Overview 8
- Chapter 2. Cyclone II DSP 9
- Development 9
- Board Components 9
- Components & Interfaces 10
- USER EPCS (U36) 11
- (Flash Memory) 11
- Expansion Connectors 13
- General Connectors 13
- DIMM_SYNC_CLK) is a 14
- CONFIG_DONEn is asserted) 15
- Featured Device 17
- User Interfaces 17
- Closed Position 19
- Open Position 19
- USER_PB3 AE14 20
- USER_PB2 AE22 20
- USER_PB1 AE16 20
- USER_PB0 AC18 20
- Audio CODEC Converter (U11) 22
- Audio Jacks (J10, J14, J16) 22
- VGA Output Connector (J21) 23
- D/A Converter (U25 & U30) 25
- D/A Converter Clocks 26
- CLK_OSC_DACA (Channel A) 27
- CLK_OSC_DACB (Channel B) 27
- FPGA_TO_DAC_CLK 27
- SMA_TO_DAC_CLK 27
- Note to Table 2–13: 28
- A/D Converter (U26 & U31) 30
- A/D Converter Clocks 31
- CLK_OSC_ADCA (Channel A) 32
- CLK_OSC_ADCB (Channel B) 32
- FPGA_TO_ADC_CLK 32
- SMA_TO_ADC_CLK 32
- Note to Table 2–18: 33
- Components 34
- DDR2 SDRAM DIMM Clocks 35
- Memory Components 36
- Note to Figure 2–12: 36
- EPCS Select (J29) 45
- Synchronous SRAM Device (U22) 47
- Note to Table 2–23: 49
- ■ EVM_CEn2 selects the SSRAM 50
- J15Pin 1 51
- Pin 1 Pin 1 51
- Notes to Figure 2–16: 52
- Note to Table 2–24: 55
- General 58
- Connectors 58
- Mictor Connector (J12) 61
- Notes to Figure 2–19: 62
- Note to Table 2–28: 64
- Status LEDs & 65
- Reset/Power 65
- Switches 65
- USER RESET 66
- SYS RESET 66
- Clock Circuitry 67
- Setting the Clocks 68
- CLK SMA Connector (J17) 69
- Clock Buffer (U16) 71
- Power Supply 72
- Power Plane 78
- Supplies 78
- Settings 78
- Appendix A. DDR2 SDRAM 79
- DIMM Connector Pin Out Table 79
- DIMM_DQS5 C12 C12 82
- DIMM_DQS6 B14 B14 82
- DIMM_DQS7 C17 C17 82
- DIMM_DQS8 B6 B6 82
- Appendix B. SSRAM 83
- Pin-Out Table 83
- Note to Ta ble B –1: 85
- Appendix C. Cyclone II EP2C70 87
- Device Pin-Out Table 87
- Appendix D. Restoring the 109
- Factory Design 109
- SAFE/USER Mode 110
- ASI Connector 111
- JTAG Cable 111
- Introduction 112
Manuais e produtos relacionados com Instrumentos de medida Altera Cyclone II DSP Development Board
Instrumentos de medida Altera Cyclone II FPGA Starter Development Board Manual do Utilizador
(56 páginas)
(56 páginas)
Instrumentos de medida Altera Cyclone III LS FPGA Development Board Manual do Utilizador
(58 páginas)
(58 páginas)
Instrumentos de medida Altera Cyclone IV GX FPGA Development Board Manual do Utilizador
(60 páginas)
(60 páginas)
Instrumentos de medida Altera Nios Development Board Cyclone II Edition Manual do Utilizador
(64 páginas)
(64 páginas)
Instrumentos de medida Altera Nios Development Board Stratix II Edition Manual do Utilizador
(62 páginas)
(62 páginas)
Instrumentos de medida Altera Stratix II GX EP2SGX90 Transceiver Signal Integrit Manual do Utilizador
(40 páginas)
(40 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.119 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais