Altera PHY IP Core Guia do Utilizador Página 25
- Página / 230
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Chapter 3: 10GBASE-R PHY IP Core 3–7
Parameter Settings
March 2012 Altera Corporation Altera Transceiver PHY IP Core
User Guide
Table 3–7 lists the analog parameters for Stratix V devices whose original values are
place holders for the values that match your electrical board specification. In
Table 3–7, the default value of an analog parameter is shown in bold type.
Table 3–7. Transceiver and PLL Assignments for Stratix V Devices (Sheet 1 of 2)
QSF Assignment Name
Pin Planner and
Assignment Editor
Name
Description Options
Assign
To
XCVR_IO_PIN_TERMINATION
Transceiver I/O Pin
Termination
Specifies the intended on-chip
termination value for the specified
transceiver pin. Use External Resistor
if you intend to use off-chip
termination.
85_OHMS
100_OHMS
120_OHMS
150_OHMS
EXTERNAL_
RESISTOR
Pin
XCVR_REFCLK_PIN_
TERMINATION
Transceiver Dedicated
Refclk Pin Termination
Specifies the intended termination
value for the specified refclk pin.
DC_COUPLING_
INTERNAL_100
_OHM
DC_COUPLING_
EXTERNAL_
RESISTOR
AC_COUPLING
Pin
XCVR_RX_BYPASS_EQ_
STAGES_234
Receiver Equalizer Stage 2,
3, 4 Bypass
Bypass continuous time equalizer
stages 2, 3, and 4 to save power. This
setting eliminates significant AC gain
on the equalizer and is appropriate for
chip-to-chip short range
communication on a PCB.
ALL_STAGES_
ENABLED
BYPASS_
STAGES
Pin
XCVR_TX_SLEW_RATE_CTRL
Transmitter Slew Rate
Control
Specifies the slew rate of the output
signal. The valid values span from the
slowest rate to fastest rate with 1
representing the slowest rate.
1–5
Pin
- User Guide 1
- Contents 3
- Chapter 7. Custom PHY IP Core 5
- Contents vi 6
- 1. Introduction 9
- Stratix V Device 10
- Reset Controller 11
- Avalon-MM PHY Management 11
- 1–4 Chapter 1: Introduction 12
- Unsupported Features 13
- 1–6 Chapter 1: Introduction 14
- 2. Getting Started 15
- Note to Figure2–2: 16
- Simulate the IP Core 18
- 3. 10GBASE-R PHY IP Core 19
- Release Information 20
- Note to Table 3–1: 21
- Stratix IV Devices 23
- Stratix V Devices 24
- SDR XGMII TX Interface 30
- Note to Table 3–9: 30
- SDR XGMII RX Interface 31
- Note to Table 3–11: 31
- Status Interface 32
- Clocks, Reset, and Powerdown 32
- Serial Interface 35
- Note to Table 3–15: 35
- TimeQuest Timing Constraints 40
- Note to Figure4–1: 43
- Note to Table 4–1: 44
- Advanced Options 51
- Configurations 52
- PMA Channel Controller 58
- Stratix IV GX Devices 65
- 5. Interlaken PHY IP Core 67
- Analog Settings 70
- Note to Figure5–2: 74
- Avalon-ST TX Interface 75
- Avalon-ST RX Interface 76
- PLL Interface 78
- TX and RX Serial Interface 78
- Optional Clocks for Deskew 78
- Transceiver Reconfiguration 81
- General Options 84
- Note to Figure6–2: 90
- PIPE Interface 92
- Note to Table 6–8: 93
- Transceiver Serial Interface 94
- Registers 95
- 7. Custom PHY IP Core 101
- Device Family Support 102
- Parameter Settings 103
- Word Alignment 106
- Rate Match FIFO 107
- 8B/10B Encoder and Decoder 108
- Byte Ordering 108
- PLL Reconfiguration 109
- Analog Options 110
- Presets for Ethernet 114
- Interfaces 115
- Note to Figure7–2: 116
- Clock Interface 118
- Status Signals (Optional) 118
- Note to Table 7–17: 119
- Register Interface 120
- Register Descriptions 121
- Dynamic Reconfiguration 124
- 8. Low Latency PHY IP Core 125
- Note to Table 8–4: 129
- Note to Table 8–5: 130
- Serial Data Interface 137
- Optional Status Interface 138
- PMA and Light-Weight PCS 139
- Arria V or Stratix V FPGA 143
- Auto-Negotiation 144
- Delay Estimation Logic 145
- Note to Figure9–2: 145
- Delay Numbers 146
- Note to Table 9–4: 147
- Additional Options 150
- TX and RX Status Signals 159
- Deterministic PHY IP Core 161
- Controller 167
- Note to Figure10–1: 169
- Note to Table 10–6: 174
- Embedded 175
- Offset Cancellation 176
- Duty Cycle Calibration 176
- PMA Analog Controls 177
- Pre-CDR Reverse Serial 178
- Loopback 178
- Post-CDR Reverse Serial 178
- ATX PLL Calibration 183
- Channel Reconfiguration 187
- Streamer Module 188
- Stratix V MIF 191
- Register-Based Write 193
- Register-Based Read 193
- Direct Write Reconfiguration 195
- Figure 10–6. Sample MIF 196
- Example 10–5. (continued) 197
- Notes to Figure 10–14: 205
- Transceiver 206
- XAUI PHY 209
- Port Differences 210
- Note to Table 11–3: 212
- Note to Table 11–5: 215
- Custom PHY 216
- Note to Table 11–6: 217
- Note to Table 11–7: 218
- Additional Information 219
- Revision History 220
- Note to Table: 228
- Typographic Conventions 229
Manuais e produtos relacionados com Software Altera PHY IP Core
Software Altera UG-01080 Guia do Utilizador
(120 páginas)
(120 páginas)
Software Altera DE2-115 Guia do Utilizador
(107 páginas)
(107 páginas)
Software Altera UG-01080 Guia do Utilizador
(484 páginas)
(484 páginas)
ViewSonic VX2770Smh-LED podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Telewizory i monitory ViewSonic VX2770Smh-LED.
Dostarczamy 1 pdf podręczników ViewSonic VX2770Smh-LED do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Comentários a estes Manuais