
Signal Direction Description
even if the V
VCCPGM
of the bank is not 3.3V if the following 2
conditions are met:
• The input signal meets the V
IH
and V
IL
specification for
LVTTL.
• The input signal meets the overshoot specification for 100°C
operation as specified by the “Maximum Allowed Overshoot
and Undershoot Voltage” in the Device Datasheet for Arria V
Devices.
Figure 4-2: Reset and Link Training Timing Relationships
The following figure illustrates the timing relationship between npor and the LTSSM L0 state.
npor
IO_POF_Load
PCIe_LinkTraining_Enumeration
dl_ltssm[4:0]
detect
detect.active polling.active
L0
Note: To meet the 100 ms system configuration time, you must use the fast passive parallel configuration
scheme with and a 32-bit data width (FPP x32).
Related Information
• PCI Express Card Electromechanical Specification 2.0
• Device Datasheet for Arria V Devices
Hard IP Status
Refer to Reset and Clocks for more information about the reset sequence and a block diagram of the reset
logic.
4-10
Hard IP Status
UG-01105_avmm
2014.12.15
Altera Corporation
Interfaces and Signal Descriptions
Send Feedback
Comentários a estes Manuais