Altera Stratix V Advanced Systems Manual do Utilizador descarregar pdf (Página 17)

Chapter 4: Development Board Setup 4–5

Factory Default Switch and Jumper Settings

February 2013 Altera Corporation Stratix V Advanced Systems Development Kit

User Guide

f For details on the JTAG chain, refer to the Stratix VAdvanced Systems Development

Board Reference Manual.

5. Set DIP switch (SW8) to match Table 4–5 and Figure 4–2 on page 4–3.

6. Set jumper blocks (J2, J3, and J12) to match Table 4–6 and Figure 4–1 on page 4–2.

f For more information about the FPGA board settings, refer to the Stratix VAdvanced

Systems Development Board Reference Manual.

Table 4–5. SW8 PCIe DIP Switch Settings

Switch Board Label Function

Default

Position

1X1

Switch 1 has the following options:

■ When on, x1 presence detect is available.

■ When off, x1 presence detect is unavailable.

Off

2X4

Switch 2 has the following options:

■ When on, x4 presence detect is available.

■ When off, x4 presence detect is unavailable.

Off

3X8

Switch 3 has the following options:

■ When on, x8 presence detect is available.

■ When off, x8 presence detect is unavailable.

Off

4X16

Switch 4 has the following options:

■ When on, x16 presence detect is available.

■ When off, x16 presence detect is unavailable.

Off

Table 4–6. Jumper Settings

Board Reference Description Shunt Position

J2 Fan 1 — 5 V and GND power Fan 1 power connected

J3 VCCIO_FMC 1.8 V Pins 1-2

J3 VCCIO_FMC 1.5 V Pins 3-4

J3 VCCIO_FMC 1.2 V Pins 5-6

J3 VCCIO_FMC 2.5 V Not installed (Default)

J12 Fan 2 — 5 V and GND power Fan 2 power connected

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Sem comentários

Altera Stratix V Advanced Systems Manual do Utilizador Página 17