Altera Stratix V Advanced Systems Manual do Utilizador descarregar pdf (Página 15)

Chapter 4: Development Board Setup 4–3

Factory Default Switch and Jumper Settings

February 2013 Altera Corporation Stratix V Advanced Systems Development Kit

User Guide

Figure 4–2 shows the switch locations and the default position of each switch on the

bottom side of the board.

To restore the switches to their factory default settings, perform the following steps:

1. Set DIP switch (SW4) to match Table 4–1 and Figure 4–2 on page 4–3.

Figure 4–2. Default Settings on the Board Bottom (Detail)

SW6

FPGA2

MSEL

1 2 3 4

SW5

FPGA1

MSEL

1 2 3 4

SW8

1 2 3 4

X1 X4 X8 X16

SW7

1 2 3 4

SW4

1 2 3 4 5 6

FPGA1_FPP

FPGA2_FPP

EXTRA0

EXTRA1

CLK_EN

CLK_SEL

HSMC JTAG

FMC

Table 4–1. SW4 DIP Switch Settings

Switch Board Label Function

Default

Position

1 FPGA1_FPP

Switch 1 has the following options:

■ When on (0), FPP x8 is enabled to configure

FPGA1 from flash location 0 and FPGA2 from flash

location 1. FPGA1 MSEL (SW5) pins and FPGA2

MSEL (SW6) pins must be set correctly.

■ When off (1), no design is configured to FPGA1 or

FPGA2 using FPP x8.

2 FPGA2_FPP — On

3EXTRA0 — Off

4EXTRA1 — Off

5 CLK_EN

Switch 5 has the following options:

■ When on (0), the on-board oscillator is disabled.

■ When off (1), the on-board oscillator is enabled.

Off

6 CLK_SEL

Switch 6 has the following options:

■ When on (0), the SMA input clock is selected.

■ When off (1), the programmable oscillator clock is

selected.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Comentários a estes Manuais

Sem comentários

Altera Stratix V Advanced Systems Manual do Utilizador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Altera Stratix V Advanced Systems