Altera Stratix V Advanced Systems Manual do Utilizador descarregar pdf (Página 14)

4–2 Chapter 4: Development Board Setup

Factory Default Switch and Jumper Settings

Stratix V Advanced Systems Development Kit February 2013 Altera Corporation

User Guide

1 The kit includes a MAX V design which contains the MAX V PFL megafunction. The

design resides in the <install dir>\kits\stratixVGX_5sgxea7nf45_as\examples\max5

directory.

When configuration is complete, the Config Done LED (D13) illuminates, signaling

that the Stratix V GX devices configured successfully.

f For more information about the PFL megafunction, refer to AN 386: Parallel Flash

Loader Megafunction User Guide.

Factory Default Switch and Jumper Settings

This section shows the factory switch and jumper settings for the Stratix V GX

advanced systems board.

Figure 4–1 shows the switch locations and the default position of each switch and

jumper on the top side of the board.

Figure 4–1. Default Settings on the Board Top (Detail)

VCCIO_FMC

1.8 V

1.5 V

1.2 V

Default:

no jumper installed

for 2.5 V

SW1

6543210

FAN1

SW3

6543210

J12

FAN2

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Sem comentários

Altera Stratix V Advanced Systems Manual do Utilizador Página 14