Altera Cyclone II EP2C35 PCI Development Board Manual do Utilizador descarregar pdf (Página 32)

3–6 Core Version 4.0.0 Altera Corporation

Cyclone II EP2C35 PCI Development Board Reference Manual May 2005

Program the Serial Flash Memory

5. Connect the USB-Blaster download cable to the active serial

configuration connector, J11.

6. Choose Add File and browse to the POF file.

7. Click Open.

8. Click Start. The user-programmable EPCS64 device is programmed

via the active serial header.

To load the program from the user-programmable EPCS64 device to the

Cyclone II device, follow these steps:

1. Power-down the board by setting the SW1 switch in the Off

position.

2. Perform a power-on reset by setting the SW1 switch in the On

position. This will load the user-programmable flash memory data

into the Cyclone II device.

Pre-Loaded, Factory-Programmed (Safe) EPCS64 Device

This section provides the steps to load the factory-created reference

design into factory-programmed (safe) EPCS64 device’s serial flash

memory via the active serial programming method.

To program the pre-loaded, factory-programmed (safe) EPCS64 device’s

serial flash memory using the Quartus II software, follow these steps:

1. Choose Programmer (Tools menu). The Chain1.cdf window

displays.

2. Scroll to Active Serial Programming in the Mode field.

3. To select the preloaded, factory-programmed EPCS64 device, set the

switch (J3) to the Up position.

4. Connect the USB-Blaster download cable to the active serial

configuration connector, J11.

5. Choose Add File and browse to the factory-programmed POF file.

6. Click Open.

7. Click Start. The factory-created reference design is loaded into the

factory-configuration region of the EPCS64 device via the active

serial header.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 49 50

Sem comentários

Altera Cyclone II EP2C35 PCI Development Board Manual do Utilizador Página 32