Altera Cyclone II EP2C35 PCI Development Board Manual do Utilizador descarregar pdf (Página 27)

Altera Corporation Core Version 4.0.0 3–1

May 2005 Preliminary

3. Using the Board

Introduction

This chapter provides step-by-step instructions for using the board. You

can configure the board with either the pre-loaded, factory-programmed

(safe) design or with a new design. This chapter discusses both.

To configure the board, there are four main steps:

■ Apply power to the board

■ Configure the Cyclone

™

II device using either:

● Serial flash configuration

● JTAG configuration via either:

• The SRAM object file (.sof)

• JTAG indirect configuration (.jic) files and the Cyclone II

device’s Serial FlashLoader (SFL) image

■ Program the serial flash memory using either:

● The conventional active serial programming method

● The SFL programming scheme for in-system programming via

the JTAG interface

■ Configure the board for bench-top operation

Apply Power to

the Board

Introduce power in one of the following ways:

■ Install the board in a universal PCI slot

■ Connect an external power supply to the external power connector

(J2)

1 No damage will occur if the external power supply is connected

while the board is installed in the PCI slot. When both power

sources are applied, the board is designed to operate from the

PCI slot’s power supply.

To operate the board with an external power supply, perform the

following steps:

1. Insert the connector of a 9 to 20-V laptop power supply into the J2

header.

2. Set the PWR SWITCH (SW1) to the On position.

Refer to Table 2–8

on page 2–8.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 49 50

Sem comentários

Altera Cyclone II EP2C35 PCI Development Board Manual do Utilizador Página 27