Altera Cyclone II EP2C35 PCI Development Board Manual do Utilizador descarregar pdf (Página 17)

Altera Corporation Core Version 4.0.0 2–7

May 2005 Cyclone II EP2C35 PCI Development Board Reference Manual

Board Components & Interfaces

Cyclone II Output Clocks

Table 2–7 lists the Cyclone II output clocks and their destinations.

Power

This section describes the on-board switching regulators. The board can

be powered from one of the following sources:

■ PCI connector J13 supplies +3.3 V and +5.0 V

■ Power connector J2 supplies +16 V from external power source

(40 W) that is regulated to 3.3 V

+3.3-V Regulator

The board contains a switching regulator (U2) that takes in the external

power source of +9 V to +20 V and regulates down to +3.3 V. All power

associated with various required voltage levels are regulated either from

the PCI 3.3-V power source or from a 3.3-V power source generated from

the power connector (stand-alone operation only). Only one power

source is required at a time.

+1.8-V Regulator

A switching regulator (U4) generates +1.8 V for the Cyclone II device I/O

and DDR2 SDRAM voltages from +3.3 V.

+1.2-V Regulator

A switching regulator (U1) generates +1.2 V for the Cyclone II internal

core voltage from +3.3 V.

Table 2–7. Cyclone II Output Clocks

Signal Name Source

Cyclone II

Device PLL

Destination

DDR2_CK_P0 U9.A22 - DDR2 SDRAM memory (U10.J8)

DDR2_CK_N0 U9.A23 - DDR2 SDRAM memory (U10.K8)

DDR2_CK_P1 U9.A9 - DDR2 SDRAM memory (U6.J8)

DDR2_CK_N1 U9.A8 - DDR2 SDRAM memory (U6.K8)

PLL_TO_PROTO1 U9.V21 PLL4 Altera daughter card (PROTO1)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 49 50

Sem comentários

Altera Cyclone II EP2C35 PCI Development Board Manual do Utilizador Página 17