Altera Arria V Avalon-ST Manual do Utilizador Página 245
- Página / 248
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Date Version Changes Made
• Removed references to the ATX PLL. This PLL is not available for
Arria V
• Removed soft reset controller .sdc constraints from the <install_dir>
/ip/altera/altera_pcie/altera_pcie_hip_ast_ed/altpcied_<dev>.sdc
example. These constraints are now in a separate file in the
synthesis/submodules directory.
• Updated Power Supply Voltage Requirements table.
2014.12.20 13.1 Made the following changes:
• Added constraints for refclk when CvP is enabled.
• Corrected location information for nPERSTL*.
• Corrected definition of test_in[4:1].
• In Debugging chapter, under changing between soft and hard reset
controller, changed the file name in which the parameter hip_
hard_reset_hwtclmust be set to 0 to use the soft reset controller.
• Added explanation of channel labeling for serial data. The Hard IP
on the left side of the device must connect to the appropriate
channels on the left side of the device, and so on.
• Corrected connection for the Transceiver Reconfiguration
Controller IP Core reset signal, alt_xcvr_reconfig_0 mgmt_
rst_reset, Getting Started with the Avalon-MM Arria V Hard IP
for PCI Express. This reset input connects to clk_0 clk_reset.
• Added definition of nreset_status for variants using the
Avalon-MM interface.
• In Transaction Layer Routing Rules and Programming Model for
Avalon-MM Root Port , added the fact that Type 0 Configuration
Requests sent to the Root Port are not filtered by the device
number. Application Layer software must filter out requests for
device number greater than 0.
• Added Recommended Reset Sequence to Avoid Link Training Issues
to the Debugging chapter.
• Added limitation for RxmIrq_<n>_i[<m>:0] when interrupts are
received on consecutive cycles.
• Updated timing diagram for tl_cfg_ctl.
• Removed I/O Read Request and I/O Write Requests from TLPs
supported for Avalon-MM interface.
• Added note that the LTSSM interface can be used for SignalTap
debugging.
• Added restriction on the use of dynamic transceiver reconfigura‐
tion when CvP is enabled.
2014.05.06
13.0
Made the following changes:
2014.12.15
Revision History for the Avalon-St Interface
C-3
Additional Information
Altera Corporation
Send Feedback
- User Guide 1
- Datasheet 2
- Features 3
- Release Information 5
- Device Family Support 6
- Altera FPGA 7
- Arria V or Cyclone V FPGA 8
- Debug Features 10
- IP Core Verification 11
- Recommended Speed Grades 11
- Qsys Design Flow 15
- Generating the Testbench 17
- Simulating the Example Design 17
- Directory Description 18
- Modifying the Example Design 21
- Parameter Settings 24
- Parameter Value Description 25
- Link Capabilities 27
- Device Capabilities 28
- Error Reporting 30
- Slot Capabilities 31
- Power Management 32
- <n> 34
- Legacy Interrupt 37
- Application Layer 39
- Avalon‑ST RX Interface 39
- Signal Direction Description 40
- Packet TLP 43
- Aligned Addresses 47
- Avalon-ST TX Interface 50
- Clock Signals 61
- Reset Signals 61
- Hard IP Status 63
- Error Signals 66
- ECRC Forwarding 66
- Interrupts for Endpoints 67
- Completion Side Band Signals 68
- Signal Directi 69
- Description 69
- Field and Bit Map 78
- 0134678951 78
- LMI Signals 79
- Hard IP for PCIe 80
- Power Management Signals 82
- 15 011623 8 2791213142431 83
- Bits Field Description 84
- Serial Interface Signals 86
- 9 Ch 18 Ch 87
- Variant Data CMU Clock 88
- PIPE Interface Signals 91
- Test Signals 95
- Registers 100
- Altera Corporation 100
- Send Feedback 100
- 2014.12.15 101
- Altera-Defined VSEC Registers 104
- CvP Registers 105
- Bits Register Description 109
- Reset and Clocks 112
- Example Design 113
- Hard IP for PCI Express 113
- Clock Domains 116
- Data Rate Frequency 117
- Related Information 117
- Clock Summary 118
- Interrupts 119
- Figure 7-1: MSI Handler Block 120
- Allocated 121
- Implementing MSI-X Interrupts 122
- Legacy Interrupts 124
- Interrupts for Root Ports 125
- Error Handling 126
- Physical Layer Errors 127
- Data Link Layer Errors 127
- Transaction Layer Errors 128
- Error Type Description 129
- Status Bit Conditions 132
- IP Core Architecture 134
- Hard IP for PCI Express 135
- Top-Level Interfaces 136
- Avalon-ST Interface 136
- Clocks and Reset 136
- Hard IP Reconfiguration 137
- Transceiver Reconfiguration 137
- Transaction Layer 138
- Configuration Space 139
- Data Link Layer 140
- Physical Layer 142
- TX Packets 143
- Multi-Function Support 144
- Supported Message Types 146
- INTX Messages 146
- Power Management Messages 147
- Error Signaling Messages 148
- Locked Transaction Message 149
- Slot Power Limit Message 149
- Vendor-Defined Messages 149
- Hot Plug Messages 150
- Receive Buffer Reordering 152
- Using Relaxed Ordering 154
- Throughput Optimization 157
- Throughput of Posted Writes 159
- Design Implementation 161
- Making Pin Assignments 162
- Optional Features 163
- ECRC on the RX Path 164
- ECRC on the TX Path 165
- Subscribe 168
- Testbench and Design Example 171
- Root Port Testbench 174
- Chaining DMA Design Examples 174
- Root Complex 176
- Chaining DMA 176
- Hard IP for 176
- PCI Express 176
- BAR/Address Map 179
- Memory BAR Mapping 180
- Bit Field Description 181
- Addr Register Name 181
- Byte Address 184
- Offset to Base 184
- Descriptor Type Description 184
- Bits[21:18] Bit[17] Bit[16] 185
- Descriptor Field Endpoint 185
- RC Access Description 185
- Test Driver Module 186
- DMA Write Cycles 187
- Shared Memory 188
- DMA Read Cycles 189
- Registers (BAR2) 190
- Root Port Design Example 191
- Root Port 192
- Variation 192
- (variation_name.v) 192
- Root Port BFM 193
- BFM Configuration Procedures 194
- BFM Request Interface 194
- BFM Memory Map 195
- Offset (Bytes) Description 197
- BFM Procedures and Functions 201
- Location altpcietb_bfm_rdwr.v 202
- Express address 203
- Shared Memory Constants 210
- Constant Description 211
- Location 216
- Debugging Simulations 228
- Debugging 229
- Setting Up Simulation 232
- Use Third-Party PCIe Analyzer 234
- BIOS Enumeration Issues 234
- Address[31:2] 235
- Figure A-6: I/O Read Request 237
- 7 6 5 4 3 2 1 0 241
- Core Config 8 4 1 241
- Additional Information 243
- Date Version Changes Made 244
- How to Contact Altera 246
- Typographic Conventions 247
- Visual Cue Meaning 248
Manuais e produtos relacionados com Instrumentos de medida Altera Arria V Avalon-ST
Instrumentos de medida Altera DDR3 SDRAM High-Performance Controller and ALTMEMP Manual do Utilizador
(10 páginas)
(10 páginas)
Instrumentos de medida Altera DDR SDRAM High-Performance Controllers and ALTMEMP Manual do Utilizador
(140 páginas)
(140 páginas)
Instrumentos de medida Altera Nios II Embedded Evaluation Kit Cyclone III Editio Manual do Utilizador
(3 páginas)
(3 páginas)
Instrumentos de medida Altera Nios II Embedded Evaluation Kit Cyclone III Editio Manual do Utilizador
(80 páginas)
(80 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.150 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais