Clocks
Frame
Generator
TX FIFO
RX FIFO
Block
Synchronizer
Frame
Synchronizer
Bit-Slip
Gearbox
Feature
64B/66B
BER
10G PCS Interface Ports
CRC32
tx_10g_coreclkin[<n>-1:0]
rx_10g_coreclkin[<n>-1:0]
tx_10g_clkout[<n>-1:0]
rx_10g_clkout[<n>-1:0]
rx_10g_clk33out[<n>-1:0]t
tx_10g_control[8<n>-1:0]
tx_10g_data_valid[<n>-1:0]
tx_10g_fifo_full[<n>-1:0]
tx_10g_fifo_pfull[<n>-1:0]
tx_10g_fifo_empty[<n>-1:0]
tx_10g_fifo_pempt[<n>-1:0]y
tx_10g_fifo_del[<n>-1:0]
tx_10g_fifo_insert[<n>-1:0]
rx_10g_control[10<n>-1:0]
rx_10g_fifo_rd_en[<n>-1:0]
rx_10g_data_valid[<n>-1:0]
rx_10g_fifo_full[<n>-1:0]
rx_10g_fifo_pfull[<n>-1:0]
rx_10g_fifo_empty[<n>-1:0]
rx_10g_fifo_pempty[<n>-1:0]
rx_10g_fifo_align_clr[<n>-1:0]
rx_10g_fifo_align_en[<n>-1:0]
rx_10g_align_val[<n>-1:0]
rx_10g_fifo_del[<n>-1:0]
rx_10g_fifo_insert[<n>-1:0]
rx_10g_crc32err[<n>-1:0]
tx_10g_diag_status[2<n>-1:0]
tx_10g_burst_en[<n>-1:0]
tx_10g_frame[<n>-1:0]
rx_10g_frame[<n>-1:0]
rx_10g_frame_lock[<n>-1:0]
rx_10g_pyld_ins[<n>-1:0]
rx_10g_frame_mfrm_err[<n>-1:0]
rx_10g_frame_sync_err[<n>-1:0]
rx_10g_scram_err[<n>-1:0]
rx_10g_frame_skip_ins[<n>-1:0]
rx_10g_frame_skip_err[<n>-1:0]
rx_10g_frame_diag_err[<n>-1:0]
rx_10g_frame_diag_status[2<n>-1:0]
rx_10g_blk_lock[<n>-1:0]
rx_10g_blk_sh_err[<n>-1:0]
rx_10g_bitslip[<n>-1:0]
tx_10g_bitslip[7<n>-1:0]
rx_10g_clr_errblk_count[<n>-1:0]
rx_10g_highber[<n>-1:0]
rx_10g_clr_highber_cnt[<n>-1:0]
PRBS
rx_10g_prbs_done
rx_10g_prbs_err
rx_10g_prbs_err_clr
The following table describes the signals available for the 10G PCS datapath. When you enable both the
PHY.
to cases where the phase compensation FIFO is not in register mode.
Table 14-44: Name Dir Synchronous to tx_10g_coreclkin/rx_10g_coreclkin Description
Comentários a estes Manuais