
Altera Corporation MegaCore Version 9.1 3–25
November 2009 QDRII SRAM Controller MegaCore Function User Guide
Functional Description
Table 3–6 shows the datapath.
control_wpsn
– Input Write signal from the pipeline and resynchronization logic.
dll_delay_ctrl
5:0 Input
DLL delay control from the top-level design to shift the
CQ by a
nominal 90 degrees.
capture_clock
– Output Capture clocks (CQ into soft logic) to the pipeline and
resynchronization logic.
captured_data
35:0 Output Captured data—data after the IO to pipeline and
resynchronization logic.
Table 3–5. Datapath Interface Signals (Part 2 of 2)
Name
Width
(Bits)
Direction Description
Table 3–6. Pipeline & Resynchronization Logic Signals
Name
Width
(Bits)
Direction Description
avl_control_a_rd
17:0 Input Read address from the control logic.
avl_control_a_wr
17:0 Input Write address from the control logic.
avl_control_bwsn
3:0 Input Byte enable from the control logic.
avl_control_rpsn
– Input Read from the control logic.
avl_control_wdata
35:0 Input Write data from the control logic.
avl_control_wpsn
– Input Write from the control logic.
capture_clock
– Input Clocks from the datapath (CQ into soft logic).
captured_data
35:0 Input Data captured by IO from datapath.
clk
– Input Clock.
reset
– Input Reset.
control_a_rd
17:0 Output Read address to datapath.
control_a_wr
17:0 Output Write address to datapath.
control_bwsn
3:0 Output Byte enable to datapath.
control_rdata
35:0 Output Read data after resynchronization to control logic.
control_rpsn
– Output Read to datapath.
control_wdata
35:0 Output Write data to datapath.
control_wpsn
– Output Write to datapath.
training_done
– Output Initial training done to control logic.
Comentários a estes Manuais