Altera ByteBlasterMV Manual do Utilizador descarregar pdf (Página 16)

1–8 Altera Corporation

Installation

cd byteblaster r

3. Run the configure install script by typing the following command at the

command prompt:

./configure r

4. Compile the Altera ByteBlaster kernel driver by typing the following

command at the command prompt:

make r

5. Become root and compile the Altera ByteBlaster kernel driver module and

device nodes by typing the following command at the command prompt:

make install r

Installing the ByteBlasterMV Download Cable on a Linux

Workstation

To install and set up the ByteBlasterMV download cable on a Linux workstation

for device configuration or programming, follow these steps:

1. Attach the ByteBlasterMV download cable to a parallel port on your Linux

workstation and insert the 10-pin female plug into the prototype system

containing the target device, as shown in Figure 1–2.

1 The board must supply power to the ByteBlasterMV download

cable.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Sem comentários

Altera ByteBlasterMV Manual do Utilizador Página 16