Altera 100G Development Kit, Stratix V GX Edition Manual do Utilizador descarregar pdf (Página 16)

4–4 Chapter 4: Development Board Setup

Factory Default Switch Settings

100G Development Kit, Stratix V GX Edition August 2012 Altera Corporation

User Guide

3. Set jumper blocks (J9, J62) to match Table 4–3 and Figure 4–1.

f For more information about the FPGA board settings, refer to the 100G Development

Kit, Stratix V GX Edition Reference Manual.

5 REFCLKB_SEL

Switch 5 has the following options:

■ When on (1), the SMA is selected.

■ When off (0), the PLL is selected.

6 CLK_644_EN

Switch 6 has the following options:

■ When on (1), 644-MHz clock is enabled.

■ When off (10, 644-MHz clock is disabled.

7 SECURITY

Switch 7 has the following options:

■ When on (1), configuration security is enabled.

■ When off (0), configuration security is disabled.

When enabled, the FPGA cannot be accessed via JTAG if the device has

already been programmed by the PFL.

8—

—

Table 4–2. SW3 DIP Switch Settings (Part 2 of 2)

Switch

Board

Label

Function

Default

Position

Table 4–3. Jumper Settings

Board Reference Description Shunt Position

Fan Bypass — Shut installed forces the fan to ON and at

full speed.

Not Installed

J62

MAX_JTAG_EN (logic 1) — Shunt installed removes

MAX II from JTAG chain.

Not Installed

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Sem comentários

Altera 100G Development Kit, Stratix V GX Edition Manual do Utilizador Página 16