Altera Transceiver Signal Integrity Manual do Utilizador descarregar pdf (Página 34)

6–10 Chapter 6: Board Test System

Using the Board Test System

Transceiver Signal Integrity Development Kit, February 2013 Altera Corporation

Stratix V GT Edition User Guide

Status

The Status control displays status information during the loopback test. For details on

this control, refer to “Status” on page 6–11.

Port

Use the following controls to select an interface to apply PMA settings, data type and

error control:

■ SFP+

■ XFP

PMA Setting

The PMA Setting button allows you to make changes to the PMA parameters that

affect the active transceiver interface. For details, refer to “PMA Setting” on

page 6–12.

Data Type

The Data type control specifies the type of data contained in the transactions. For

details, refer to “Data Type” on page 6–12.

Error Control

This control displays data errors detected during analysis and allows you to insert

errors. For details, refer to “Error Control” on page 6–13.

Loopback

This control allows you control and analyze loopback performance. For details, refer

to “Loopback” on page 6–13.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 55 56

Sem comentários

Altera Transceiver Signal Integrity Manual do Utilizador Página 34