Altera SoC Embedded Design Suite Manual do Utilizador Página 176

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 207
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 175
BSP Setting Type Default Value Description
spl.boot.FAT_BOOT_PARTITION Decimal 1
When FAT partition support is
enabled, this specifies the FAT
partition where the boot image is
located.
spl.boot.FAT_LOAD_PAYLOAD_NAME String u-boot.img
When FAT partition supported
is enabled, this specifies the boot
image filename to be used.
spl.boot.WATCHDOG_ENABLE Boolean True
This setting enables the
watchdog during the preloader
execution phase. The watchdog
remains enabled after the
preloader exits.
spl.boot.CHECKSUM_NEXT_IMAGE Boolean True
This setting enables the
preloader to validate the
checksum in the subsequent boot
image header information.
spl.boot.EXE_ON_FPGA Boolean False
This setting executes the
preloader on the FPGA. Select
spl.boot.EXE_ON_FPGA when
the preloader is configured to
boot from the FPGA.
spl.boot.STATE_REG_ENABLE Boolean True
This setting enables writing the
magic value to the
INITSWSTATE register in the
system manager when the
preloader exists; this indicates to
the boot ROM that the preloader
has run successfully.
spl.boot.BOOTROM_HANDSHAKE_CFGIO Boolean True
This setting enables handshake
with boot ROM when
configuring the IOCSR and pin
multiplexing. If
spl.boot.BOOTROM_HANDSHAKE_
CFGIO is enabled and warm reset
occurs when the preloader is
configuring IOCSR and pin
multiplexing, the boot ROM will
reconfigure IOCSR and pin
multiplexing again. This option
is enabled by default.
ug-1137
2013.05.03
Available BSP Settings
7-11
HPS Preloader User Guide
Altera Corporation
Send Feedback
Vista de página 175
1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 206 207

Comentários a estes Manuais

Sem comentários