Altera Nios Development Board Cyclone II Edition Manual do Utilizador descarregar pdf (Página 39)

Altera Corporation Reference Manual 2–27

May 2007 Nios Development Board Cyclone II Edition

Board Components

Figure 2–11. PMC Connector

The PMC connector supplies +3.3V, +5V and +/- 12V, as required by the

PCI specification. However, DC power regulators for these supplies

cannot provide enough power to fully satisfy the PCI power specification.

The current that the board can supply through JH1 and JH2 is dependent

on the design configured in the FPGA. As a general guideline, if the PMC

card power requirements exceed the specifications shown in Table 2–14,

you must connect an external power source.

w When connecting an external power supply, the fuse for the

corresponding voltage should be removed to prevent the two

power supplies from interfering with each other. Refer to

“Power-Supply Circuitry” on page 2–44 for more information.

Table 2–15 lists the connections between the PMC connector and the

FPGA.

Table 2–14. PMC Card Power Specifications

DC Supply Maximum Power Apply External Power Source

+3.3V 9.5 Watts J29

+5V 15 Watts J28

+12V 45 Watts J31

-12V 1.2 Watts TP13

Table 2–15. PMC Connector Pin Table

FPGA Pin JH1 & JH2 Pin Connector Board Net Name

L20 61 JH1 pmc_ad0

L21 60 JH1 pmc_ad1

Pin 1

JH2

JH1

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 63 64

Sem comentários

Altera Nios Development Board Cyclone II Edition Manual do Utilizador Página 39