Altera MAX 10 FPGA Manual do Utilizador descarregar pdf (Página 11)

Chapter 2: Getting Started 2–3

Factory Default Switch and Jumper Settings

October 2014 Altera Corporation MAX 10 FPGA (10M08S, 144-EQFP) Evaluation Kit

User Guide

5 User-defined On

BOOT_SEL: Use this switch to choose CFM0, CFM1, or

CFM2 image as the first image in a dual-image configuration.

If BOOT_SEL is set to low, the first boot image is CFM0

image, If set to high, the first boot image is the CFM1 or

CFM2 image. By default, the FPGA setting for this pin is tri-

stated.

Table 2–2. Default Jumper Settings

Jumper Function Setting

Jumper for analog input channel #8. Default connection is to

GND.

Pins 2 and 3

Jumper for analog input channel #7. Default connection is to

potentiometer.

Pins 2 and 3

Table 2–1. Default SW3 DIP Switch Settings (Part 2 of 2)

Switch Function

Default

Position

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Sem comentários

Altera MAX 10 FPGA Manual do Utilizador Página 11