Altera MasterBlaster Serial/USB Manual do Utilizador descarregar pdf (Página 11)

Chapter 1: Installing the MasterBlaster Serial/USB Communications Cable 1–3

Installation

1 The USB option is available only for Windows 2000, Windows XP x32 edition and

Windows Vista x32 edition systems.

1 The COM option is available only for Windows 2000, Windows XP x32 edition,

Windows XP x64 edition and Windows Vista x32 edition systems.

7. In the Port list, select the appropriate port.

8. If you are using a serial port, in the Baud rate list, select a baud rate appropriate

for your computer.

9. Click OK to close the Add Hardware dialog box. You will see MasterBlaster in the

Available hardware items section of the Hardware Setup dialog box.

10. Click on MasterBlaster to highlight it, then click on the Select Hardware button to

the right of the Available hardware items section. You will now see MasterBlaster

and your selected port in the Currently selected hardware section of the window,

as shown in Figure 1–2.

11. Click Close to close the Hardware Setup dialog box.

12. Close the Programmer window.

Installation on a Linux or UNIX Workstation

To install and set up the MasterBlaster cable for device configuration or programming

on a Linux or UNIX Workstation, follow these steps:

1. With a standard RS-232 cable, connect one end of the cable to the MasterBlaster

cable, and connect the other end of the cable to the appropriate port on the

computer.

2. Connect the 16-pin female header end of the cable to the 16-pin male MasterBlaster

port, and the 10-pin female end of the cable to the 10-pin male header on the target

printed circuit board, as shown in Figure 1–1.

Figure 1–2. The Hardware Setup Dialog Box

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Sem comentários

Altera MasterBlaster Serial/USB Manual do Utilizador Página 11