Altera High-Speed Development Kit, Stratix GX Edition Manual do Utilizador descarregar pdf (Página 55)

Altera Corporation Quartus II Version 3.0 5–11

Perform the Production Diagnostic Tests Perform the Standard Tests

3. Click Auto-Detect. The Stratix, Stratix GX, and 2 EPC16 devices

display in the JTAG chain.

4. Change the programming file for the Stratix GX device:

a. Right-click the filename next to the Stratix GX device.

b. Browse to the standard SOFs directory.

c. Select the file GX40_User_IO.sof.

d. Click Open. Wait until the checksum field is updated.

5. Change the programming file for the Stratix device to

STX40_User_IO.sof using the steps described above. Wait until the

checksum field is updated.

6. Turn on the Program/Configure option for the Stratix and

Stratix GX devices. See Figure 5–15.

Figure 5–15. Quartus II Programmer for the User I/O Test

7. Click Start to configure both devices. When configuration is

complete for both devices, the GX_CONF_DONE (D7) and

S_CONF_DONE (D6) LEDs illuminate as shown in Figure 4–1 on

page 4–2.

8. Test the user I/O for the Stratix GX device by performing steps 1

through 12 in “Run the User I/O Test” on page 4–3.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 139 140

Sem comentários

Altera High-Speed Development Kit, Stratix GX Edition Manual do Utilizador Página 55