
Chapter 2: Board Components 2–21
General User Input/Output
March 2013 Altera Corporation Cyclone V E FPGA Development Board
Reference Manual
Table 2–13 lists the user-defined push button schematic signal names and their
corresponding Cyclone V E FPGA pin numbers.
User-Defined DIP Switch
Board reference SW3 is a four-pin DIP switch. This switch is user-defined and
provides additional FPGA input control. When the switch is in the OFF position, a
logic 1 is selected. When the switch is in the ON position, a logic 0 is selected. There
are no board-specific functions for this switch.
Table 2–14 lists the user-defined DIP switch schematic signal names and their
corresponding Cyclone V E FPGA pin numbers.
User-Defined LEDs
The development board includes general and HSMC user-defined LEDs. This section
describes all user-defined LEDs. For information on board specific or status LEDs,
refer to “Status Elements” on page 2–15.
General LEDs
Board references D28 through D31 are four user-defined LEDs. The status and
debugging signals are driven to the LEDs from the designs loaded into the
Cyclone V E FPGA. Driving a logic 0 on the I/O port turns the LED on while driving a
logic 1 turns the LED off. There are no board-specific functions for these LEDs.
Table 2–13. User-Defined Push Button Schematic Signal Names and Functions
Board Reference Schematic Signal Name
Cyclone V E FPGA Pin
Number
I/O Standard
S5
USER_PB0
AB12 2.5-V
S6
USER_PB1
AB13 2.5-V
S7
USER_PB2
AF13 2.5-V
S8
USER_PB3
AG12 2.5-V
Table 2–14. User-Defined DIP Switch Schematic Signal Names and Functions
Board Reference Schematic Signal Name
Cyclone V E FPGA
Pin Number
I/O Standard
1
USER_DIPSW0
Y12 2.5-V
2
USER_DIPSW1
AA13 2.5-V
3
USER_DIPSW2
AF11 2.5-V
4
USER_DIPSW3
AG11 2.5-V
Comentários a estes Manuais