Altera Arria II GX FPGA Manual do Utilizador descarregar pdf (Página 9)

February 2011 Altera Corporation Arria II GX FPGA Development Kit User Guide

2. Getting Started

The remaining chapters in this user guide lead you through the following Arria II GX

FPGA development board setup steps:

■ Inspecting the contents of the kit

■ Installing the design and kit software

■ Setting up, powering up, and verifying correct operation of the FPGA

development board

■ Configuring the Arria II GX FPGA

■ Running the Board Test System designs

f For complete information about the FPGA development board, refer to the Arria II GX

FPGA Development Board Reference Manual.

Before You Begin

Before using the kit or installing the software, check the kit contents and inspect the

board to verify that you received all of the items listed in “Kit Features” on page 1–1.

If any of the items are missing, contact Altera before you proceed.

Inspect the Board

To inspect the board, perform the following steps:

1. Place the board on an anti-static surface and inspect it to ensure that it has not been

damaged during shipment.

c Without proper anti-static handling, you can damage the board.

2. Verify that all components are on the board and appear intact.

1 In typical applications with the Arria II GX FPGA development board, a heat sink is

not necessary. However, under extreme conditions or for engineering sample silicon

the board might require additional cooling to stay within operating temperature

guidelines. You can perform power consumption and thermal modeling to determine

whether your application requires additional cooling. The board has two holes near

the FPGA that accommodate many different heat sinks, including the Dynatron V31G.

f For more information about power consumption and thermal modeling, refer to

AN 358: Thermal Management for FPGAs.

c To avoid damage to the board, always have the board POWER switch (SW1) in the

OFF position before inserting the DC power jack (J4).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Sem comentários

Altera Arria II GX FPGA Manual do Utilizador Página 9